Single-ingredient colourless acrylic varnish to provide surface protection or to cover paint imperfections. Highly weather resistant. Can be used almost any surface.
- 100% gloss acrylic varnish
- Αdds a sheen, protects and resists dirt retention
- Dries clear to a flexible, non-tacky, hard surface
- Increases brightness and colour saturation
- Adjusts and unifies surface sheen
- Improves surface durability - ideal when shipping or exhibiting
- Protects colours from UV light damage
- Resists discolouration - yellowing and fogging - caused by humidity, heat and UV
- Depending on the substrate it allows surface moisture to pass through and breathe
- Allows for easy cleaning without fear of damaging the acrylic paint film
- Has excellent levelling properties - will not hold brush marks
- Transparent when dry
- Flexible & non-cracking
- Water-resistant when dry
- Ideal for complete coverage of heavy textures and vertical applications
- Designed for interior and exterior use
- 400ml
APPLICATION
CAN BE USED ON ANY SURFACE.
CAP SYSTEM
SMART CAP
– Less overspray
– Extreme coverage
– Fast drying
– Hard chisel lines
– Even coating
– Suitably for effects
– Dual way spraying
INSTRUCTIONS FOR USE
Shake the container at least 3 minutes after you hear the mixing ball. Before the first use spray it in the air for 3-4 seconds. After use turn the aerosol upside down and press the actuator for 2-3 seconds to clean the valve. If the nozzle is blocked, replace it with a new one. Use outdoors or in a well-ventilated area such as an open garage. Optimal application at temperature: 10-25°C and humidity below 65% to ensure proper drying. Storage 5-35°C.
TIPS:
- Ensure the surface is clean, dry, and free of grease
- Wear protective gloves, protective clothing, eye/face protection
- Always paint in an open space in the open air
- The space should be as dust-free as possible
- Protect the surrounding area from overspray
- Test spray on a non-visible area
- Always spray with the can in a vertical position, otherwise the paint might 'spit' unevenly
- Spray surface from a distance of 25-30cm
- Apply in several thin layers, spraying in sweeping motions
- Don't go over bits you have missed, but leave to dry and then re-varnish area. Don't go back over areas you have already done, as this can cause clouding
- Don't attempt to remove once applied
- Do not use with any non-acrylic media
- After use, clean the spray valve (turn the aerosol upside down and push the nozzle for about 5 seconds)
